Pipe shredder

Pipe shredder as a waste plastic processing and recycling equipment relative to plastic shredder This machine is more compact and convenient in structure, generally can be used to process unprocessed raw materials or scraps, making it smaller in size. A representative example is that the scrap of a plastic pipe or a rubber pipe is shredded and then pulverized as a raw material. The large pipe shredder is usually a single-shaft shredder. The blade is mounted on the spindle to scrape and tear the rubber pipe near the main shaft. The thick rubber pipe is gradually reduced by pushing the pusher plate. The limit dead angle of the material plate realizes the complete crushing of the rubber pipe, and the discharge size can be limited according to the size. However, in consideration of the production problem and the efficiency problem, if the fine crushing is required, the plastic pulverizer can be disposed behind the machine to achieve high productivity and high efficiency. .

Institutional principle
The large-diameter pipe shredder is mainly composed of motor, hard-tooth surface reducer, rotary cutter shaft, imported movable knife, fixed knife, frame, base, box, hydraulic cylinder, oil pump, cylinder, etc. Structure and composition. The fixed cutter is mounted on the frame, and the rotary cutter shaft is equipped with a detachable embedded movable knife. The number of movable cutters is determined according to different models and the size of the rotary cutter shaft, and the movable cutter is a square surface and can be used with a knife. The angle is changed until the four sides are blunt and then sharpened. Because it is a claw type moving knife, rotary cutting, and the fixed knife and moving knife are made of Japanese SKD11. After heat treatment, the hardness reaches HRC60° or more, so the service life is long. The cutting ability is strong, the production capacity is high, and the normal use of more than 1000 tons requires grinding. When the machine is working, the material is propelled by a hydraulic cylinder and equipped with a pneumatic clamping device. Hongyuan Machinery adopts PLC programmable control in equipment control, with high degree of automation and easy operation. During the whole operation, it is only necessary to start the large-diameter pipe shredder and the loading machine. After the material enters the machine cavity, the material is close to the main shaft of the machine under the push of the hydraulic push plate, and the material is gradually reduced by the continuous cutting of the movable knife until the crushing is completed. During the period, you can continue to feed.